D-Link DMC-805G User Manual

Setup The DMC-805G
Single Fiber Media

Converter

As with any electric device, you should
place the equipment where it will not
be subjected to extreme temperatures,
humidity, or electromagnetic
interference. Specifically, the site you
select should meet the following
requirements:

A. The ambient temperature should be

between 32 and 104 degrees
Fahrenheit (0 to 40 degrees Celsius).

B. The relative humidity should be less
than 90 percent, non-condensing.
C. Surrounding electrical devices should

not exceed the electromagnetic field
(RFC) standards for IEC 801-3, Level
2 (3V/M) field strength.

D. Make sure that the equipment receives

adequate ventilation. Do not block the
ventilation holes on each side of the
media converter or the fan exhaust
port on the side or rear of the
equipment.

E. The power outlet should be within 1.8
meters of the switch.

Connecting the power

1. This Converter is a plug-and-play

device.

2. Connect the supplied AC to DC

power adaptor with a power
voltage of 7.5Vdc/1.5Amp to the
receptacle on the rear panel of the
converter, and then attach the plug
into a standard AC outlet with a
voltage range from 100 to 260
Vac.

Sliding Switch

There is a sliding switch for duplex mode
setting for fiber port. Refer to the table
below for more details.

1 2

Switch 1 : On -> Forced Mode

Off -> Auto Negotiation mode

Switch 2 : On -> LLR enable

Off -> LLR disable

Installing in a
Chassis

The Converter can be fit into any

of the expansion slots on a special
designed chassis.

First, install the converter onto a carrier

supplied with the chassis:
Step 1- Unscrew the carrier from the
desired expansion slot on the chassis.
Step

Remove the screw on the

converter as shown below.
Step

Fit the converter onto the

carrier and use the screw to secure it.

On Fiber Forced Mode

Switch 1

Off Fiber

Auto-Negotiation

On LLR

Enable

Switch 2

Off LLR

Disable

Unscrew and pull out the media converter board