Datacard Group RL90 User Manual
Laminator error recovery
RP90 Plus E and RL90 User Guide
65
Laminator LCD messages
LCD Message
Possible Cause
Solution
Please Power OFF
To initialize this unit, the
power must be switched
off once.
power must be switched
off once.
Turn the laminator’s power switch off, and then back
on to initialize the laminator.
on to initialize the laminator.
Please Reset
Displayed when Reset is
necessary after changing
the settings.
necessary after changing
the settings.
Press the RESET/K and then the ENTER key to
initialize the laminator.
initialize the laminator.
Please check inside
The power was switched
off during lamination.
off during lamination.
Remove the laminator cartridge and check for a card
inside the machine. If there is a card in the machine,
remove it.
Press the RESET/K and then the ENTER key to
initialize the laminator.
inside the machine. If there is a card in the machine,
remove it.
Press the RESET/K and then the ENTER key to
initialize the laminator.
Card Jam (in)
There is a card jam in the
entrance area.
entrance area.
.
See
to clear the jam.
Card Jam (middle)
There is a card jam in the
center of the card path.
center of the card path.
The laminating temperature is too high or the speed is
too slow. Set the temperature or speed as described in
too slow. Set the temperature or speed as described in
See
to clear the jam.
Card Jam (out)
There is a card jam in the
card discharge area.
card discharge area.
The laminating temperature is too high or the speed is
too slow. See
too slow. See
to clear the
jam.
Film search
The laminator is searching
for laminate material.
for laminate material.
.
Press the RESET/K and then the ENTER key to
initialize the laminating material.
initialize the laminating material.
Film run out
The end of the roll mark
has been detected.
has been detected.
Replace the laminating material as described in
Press the RESET/K and then the ENTER key to
initialize the laminator.
initialize the laminator.
No Cassette
The laminator cartridge is
not installed.
not installed.
Install the laminator cartridge as described in
Press the RESET/K and then the ENTER key to
initialize the laminator.
initialize the laminator.
Overcool
The area surrounding the
laminator is too cold.
laminator is too cold.
See
for
location guidelines.
HR is too hot!
The heat roller is too hot
for the cleaning operation.
for the cleaning operation.
Turn the power switch off and allow the roller to cool
before attempting to clean it. See
before attempting to clean it. See
to clean the heat roller.