BMW 2010 750Li Sedan Owner's Manual

Page of 280
Functional requirements
To lock the vehicle, the remote control must
be located outside of the vehicle.
The next unlocking and locking cycle is not
possible until after approx. 2 seconds.
The engine can only be started if the remote
control is inside the vehicle.
Comparison with ordinary remote
control
The functions can be controlled by pressing the
buttons or via Comfort Access.
Releasing
Fully grasp a door handle, arrow 1. This corre‐
sponds to pressing the     button.
Locking
Press the area on the door handle, arrow 2, with
your finger for approx. 1 second.
This corresponds to pressing the     button.
To save battery power, ensure that the ignition
and all electronic systems and/or power con‐
sumers are switched off before locking the ve‐
hicle.
Unlocking the trunk lid separately
This corresponds to pressing the  
  button.
If a remote control accidentally left in the trunk
is detected in the locked vehicle, then the trunk
lid opens again.
Ignition on
Pressing the Start/Stop button switches the ig‐
nition on.
When doing so, do not depress the brake pedal;
otherwise, the engine will start.
Malfunction
Comfort Access may not function properly if it
experiences interference from local radio waves,
e.g., mobile phones.
If this occurs, open or close the vehicle using the
buttons on the remote control or use a key in the
door lock.
To subsequently start the engine, hold the re‐
mote control against the marked 
.
Alarm system*
The concept
The vehicle alarm system responds to:
Opening of a door, the hood or the trunk lid.
.
Changes in the vehicle tilt, e.g., during at‐
tempts to steal a wheel or tow the car.
Interruptions in battery voltage.
The alarm system briefly indicates tampering:
By sounding an acoustic alarm.
By switching on the hazard warning system.
By flashing the high beams.
Seite 41
41
Online Edition for Part no. 01 41 2 602 638 - © 09 09 510 BMW AG