BMW 2009 X6 xDrive50i Owner's Manual

 123

The integrated universal remote control can 
replace as many as three hand-held transmit-
ters for various remote-controlled accessories, 
such as garage and gate or lighting systems. 
The integrated universal remote control regis-
ters and stores signals from the original hand-
held transmitters.
The signal of an original hand-held transmitter 
can be programmed on one of the three mem-
ory buttons

1. Then with the ignition switched 

on, this programmed memory button

1 can be 

used to operate the respective feature. The 
LED

2 flashes to confirm transmission of the 

signal.
Should you sell your vehicle one day, be sure to 
delete the stored programs beforehand for your 
safety, refer to page

To prevent possible damage or injury, 
before programming or using the inte-

grated universal remote control, always inspect 
the immediate area to make certain that no peo-
ple, animals or objects are within the travel 
range of the device. Also, comply with the 
safety precautions of the original hand-held 
transmitter.

<

If you see this symbol on the packaging 
or in the manual supplied with the orig-
inal hand-held transmitter, it is safe to 

assume that it is compatible with the integrated 
universal remote control.

Should you have additional questions, 
please contact your BMW Sports Activity 

Vehicle Center or call: 1-800-355-3515.
Information is also provided on the Internet at:
www.bmwusa.com or
www.homelink.com.

HomeLink is a registered trademark of Johnson 
Controls, Inc.

<

1 Memory buttons
2 LED

1.

Switch on ignition, refer to page

2.

When starting operation for the first time: 
Press the left and right-hand memory but-
ton

1 for approx. 20 seconds until the 

LED

2 flashes quickly. All stored programs 

are deleted.

3.

Hold the original hand-held transmitter at 
a distance of approx. 4 in/10 cm to 12 in/
30 cm from the memory buttons

1.

The required distance between the 
hand-held transmitter and the mem-

ory buttons

1 depends on the relevant sys-

tem of the original hand-held transmitter 
used.

<

4.

Simultaneously press the transmit button 
on the original hand-held transmitter and 
the desired memory button 

1 on the inte-

grated universal remote control. The LED 

2 

flashes slowly at first. As soon as the LED

2 

flashes rapidly, release both buttons. If the 
LED

2 does not flash rapidly after approx. 

15 seconds, alter the distance and repeat 
the step.

5.

To program other original hand-held trans-
mitters, repeat steps 3 and 4.

Online Edition for Part no. 01 41 2 600 809 - © 09/08 BMW AG