Brother CS-8150 Owner's Manual
17
1
f
While holding the thread as shown below,
pull it between the tension discs.
pull it between the tension discs.
g
Guide the thread through the thread take-up
lever from right to left.
lever from right to left.
a
Thread take-up lever
h
Put the thread behind the needle bar thread
guide above the needle.
The thread can easily be passed behind the
needle bar thread guide by holding the thread
in your left hand, then feeding the thread with
your right hand.
guide above the needle.
The thread can easily be passed behind the
needle bar thread guide by holding the thread
in your left hand, then feeding the thread with
your right hand.
a
Needle bar thread guide
i
Thread the needle from front to back and pull
out about 5 cm (2 inches) of thread.
out about 5 cm (2 inches) of thread.
a
5 cm (2 inches)
Note
● If the thread take-up lever is lowered, the
upper thread cannot be wrapped around the
thread take-up lever. Make sure you raise
the presser foot lever and the thread take-up
lever before you feed the upper thread.
thread take-up lever. Make sure you raise
the presser foot lever and the thread take-up
lever before you feed the upper thread.
● If you incorrectly feed the thread you may
cause sewing problems.
LS2125_01.fm Page 17 Tuesday, February 26, 2008 2:58 PM