Brinsea Octagon 20 Advance User Manual

AD21 GB Issue 01

13

12.3  If a separate hatcher is used the procedure above should still be followed every two months.

12.4  The exterior of the incubator and Autoturn cradle may be cleaned with a damp cloth. Avoid allowing any

moisture to get inside mechanical housings.

12.5  Always clean the incubator before storage and ensure that the unit is totally dry inside and out.

IMPORTANT: THE HEATER CORD AND CONNECTIONS ARE AT MAINS VOLTAGE. NEVER
OPERATE THE INCUBATOR WITH THE FAN COVER REMOVED. RISK OF ELECTRIC SHOCK!

13.1  In case of failure first check that the mains power supply is working and that the mains cable connector is

fully engaged in the socket beneath the cable cover. The digital control system may be reset to the
original factory defaults by connecting the power supply while holding the OK button. Check temperature
calibration after resetting to defaults.

If the problem persists contact your distributor or Brinsea Products Service Dept.

13.2  The functional parts of the Octagon 20 Advance are modular and parts are available and are readily

exchanged by a suitably qualified person equipped with basic tools. Fitting instructions are supplied with
replacement parts.

13.3  The digital temperature and humidity display is individually calibrated during manufacture but may be re-

calibrated if required. To ensure optimal performance return the incubator to Brinsea Products Service
dept. for re-calibration every two years. It is not recommended that this procedure is carried out by the
user.

BE CAUTIOUS OF LOW COST ANALOGUE OR DIGITAL THERMOMETERS AND
HYGROMETERS.

BRINSEA PRODUCTS LTD USES SOPHISTICATED EQUIPMENT TRACEABLE TO
INTERNATIONAL REFERENCE STANDARDS.

To access the Calibration Menu press all three buttons simultaneously to unlock the display.