Bosch 24" Compact Condensation Dryer Axxis WTB86201UC Owner's Manual

14

Unplug the current power cord being used from the 

outlet/receptacle.

To disconnect and/or reconnect a new power cord 

you must remove the top cover of the appliance as 

shown below. 
A. Remove the two T20 torx head screws.

B. Push the top cover toward the rear of the appliance

and lift up.

Open the connection box toward the rear of the 

appliance by removing the T20 torx head screw 

fastening the cover.

Remove the 4-wire power cord (as supplied):
A. Remove the 3 Philips screws (2 labeled L and one

labeled N).

B. Remove the green grounding screw PE (T20 torx).
NOTICE:  Be careful not to drop the screws into the 

dryer.

Loosen the strain relief clamp screw (Philips head) on 

rear of the connection box.

Pull the old power cord out of the connection box.

Install the new power cord back through the strain 

relief clamp.
NOTICE:  Ensure the strain relief clamp has not been 

moved and its clamping screw(s) are outside the rear 

of the connection box.

Ensure the terminal ends are long enough and are 

formed (bent) so that no part of them (wires or 

terminal ends) come in contact with connection box 

enclosure.
NOTICE:  Use only open-end spade lugs.

Ensure the terminal ends are long enough and are 

formed (bent) so they will align with the terminal block 

fastening locations (screw holes).

Reinstall the 2 terminal block screws (Philips head) at 

locations L as shown below.

If the ground wire shown below from N to PE is not 

part of the 3-wire cord assembly you have it must be 

obtained/purchased separately and it must be 

installed.

Install the last terminal block screw (Philips) and 1 

grounding screw (T20 torx) at locations N and PE.

Tighten the strain relief screw ensuring the power cord 

cannot be pulled out of the connection box but not so 

tight as cut the power cord insulation.

Reinstall the connection box cover making sure all 

wires are routed so they do not touch any part of the 

enclosure and are secure.

Reinstall the appliance top cover as previously 

described in “2” point above.

Integrated electrical receptacle
This appliance is equipped with a 208/240V 15A 

receptacle for use ONLY with Bosch washer listed below. 

9

Do not use this receptacle to power any other 

device.

If any other electrical device is plugged into this 

receptacle Bosch will assume no liability.

9

Use integrated electrical receptacle only for these 

Bosch washer listed:
WAP24200UC, WAP24201UC, WAP24202UC,
WAS24460UC, WAS20160UC, WAE20060UC. 

Importance of leveling the dryer
It is important that your dryer is level and that all four 

dryer feet press with equal pressure against the floor. 

This will help assure the quietest, most vibration-free use 

of your dryer.