Bosch Appliances Washer/Dryer WAP24201UC User Manual

24

Liquid detergent dispenser
To measure liquid detergent:

Pull out the detergent drawer. Press down on the insert 

and remove the drawer completely.

Push the liquid detergent dispenser forward.

Insert the drawer again.

NOTICE:  Do not use the liquid detergent dispenser with 

gel-type detergents and powdered detergents or for 

cycles with pre-wash and selected "Finish at" time.

Press the Start/Pause button Indicator lamp lights up 

and the cycle starts.
NOTICE:  If you want to protect the cycle against 

inadvertent adjustment, select the child lock. 
~ Child lock; Page 24
During the cycle, the display field indicates the "Finish at" 

time and, after starting the washing cycle, the cycle 

duration and the symbols for the cycle progress.
~ Display field; Page 16

You can secure the washer against inadvertent changing 

of the set functions. To do this, activate the child lock 

after cycle start.
To Activate/Deactivate,  press Start/Pause for approx. 5 

seconds. In the display field, you will see the 

D

 symbol.

▯

D

 lit steady: The child lock is active.

▯

D

 blinking: The child lock is active and the cycle 

selector has been adjusted. To prevent a cycle 

interruption, set the cycle selector back to the initial 

cycle. The symbol lights up again.

NOTICE:  The child lock can remain activated until the 

next cycle start even after switching the machine off. 
Then you must deactivate the child lock before cycle 

start and if necessary activate it again after cycle start.

If you have inadvertently started the wrong cycle, you can 

change this as follows:

Press Start/Pause.

Select another cycle.

Press Start/Pause. The new cycle starts from the 

beginning.

e.g. for soaking ~ Soaking; Page 20
Press Start/Pause. - 

¿

 - appears on the display panel; 

washing machine door cannot be opened. To continue 

the cycle, press Start/Pause.

For cycles with a high temperature:

Press Start/Pause.

Cool the laundry off: Select Rinse.

Press Start/Pause.

For cycles with a low temperature:

Press Start/Pause.

Select Spin/Drain.

Press Start/Pause.

Appears in the display field – – – and the indicator lamp 

on the Start/Pause button blinks.
In order to exit the cycle, set the cycle selector to Spin/

Drain or select a spin speed range, then press the Start/

Pause button.

End  appears in the display field and the Start/Pause 

button indicator lamp is off.
If the cycle status sequence Wash is also flashing in the 

display field, the washer has detected too much foam 

during the washing cycle and it has then automatically 

switched on a rinse to remove the foam.
NOTICE:  Use less detergent the next time you run the 

washer with the same load.

Open the front door of the washer and remove the 

laundry.

Turn the cycle selector to the Off position. Appliance is 

switched off.

Turn off the water tap.

▯

Do not leave any laundry in the drum. It can shrink or 

be discolored by the next laundry.

▯

Remove any remaining items from the drum and 

rubber gasket.