Bosch 2400E User Manual
12
Troubleshooting
6 720 606 990
5
Troubleshooting
5.1
Replacing batteries
When batteries are weak, the symbol
(Fig. 2, pos. 5) will appear on the
display.
(Fig. 2, pos. 5) will appear on the
display.
B Remove the two screws on the back
of the remote control.
B Open the battery housing and
remove the batteries, then replace
with new AA LR6 1.5V batteries,
ensuring they are inserted correctly.
with new AA LR6 1.5V batteries,
ensuring they are inserted correctly.
B Close the battery housing using the
two screws.
5.2
Cleaning
Use a damp cloth to clean parts of the
remote control. Do not use abrasive or
solvent-based detergents.
remote control. Do not use abrasive or
solvent-based detergents.
5.3
Troubleshooting
1. No display on remote control
B Check for weak or dead batteries
(see section 5.1).
Remote control in sleep mode.
B simply press any button on the
remote to bring up the display.
2. Remote control will not activate
/ no number with rotating digit
/ no number with rotating digit
B Ensure that you are standing directly
in front of the water heater when
attempting to activate.
attempting to activate.
B Ensure that no other device in the
area, such as a cordless phone, is
operating on a frequency similar to
the remote (915 MHz) and causing
interference.
operating on a frequency similar to
the remote (915 MHz) and causing
interference.
i
Verify that the rubber
seal is correctly fitted
between both plastic
housing parts.
seal is correctly fitted
between both plastic
housing parts.
Warning:
dead bat-
teries must be
replaced.
Consequently, the
manufacturer is not
liable for any faults or
damage caused by
dead batteries.
Dispose of the dead
batteries properly.
replaced.
Consequently, the
manufacturer is not
liable for any faults or
damage caused by
dead batteries.
Dispose of the dead
batteries properly.
i
If not used for a few
minutes, the remote's
display will go blank to
save batteries.
minutes, the remote's
display will go blank to
save batteries.
6720606990-0701_(Remote control).fm Page 12 Tuesday, January 30, 2007 10:07 AM