Bosch Appliances Security Camera NDN-932 User Manual

en | Maintenance

FLEXIDOME HD

AM18-Q0615 | v1.0 | 2012.10

Installation Manual

Bosch Security Systems

The ping command can be used to check the connection 

between two IP addresses. This allows testing whether a device 

is active in the network.

1.

Open the DOS command prompt.

2.

Type ping followed by the IP address of the device.

If the device is found, the response appears as " Reply from ... ", 

followed by the number of bytes sent and the transmission time 

in milliseconds. Otherwise, the device cannot be accessed via 

the network. This might be because:

–

The device is not properly connected to the network. 

Check the cable connections in this case.

–

The device is not correctly integrated into the network. 

Check the IP address, subnet mask, and gateway address. 

The camera should only be passed on together with this 

installation guide. The unit contains environmentally hazardous 

materials that must be disposed of according to law. Defective 

or superfluous devices and parts should be disposed of 

professionally or taken to your local collection point for 

hazardous materials.

Never open the casing of the unit. The unit does not contain any 

user serviceable parts. Ensure that all maintenance or repair 

work is performed only by qualified personnel (electrical 

engineering or network technology specialists). In case of 

doubt, contact your dealer's technical service center.