Bosch Appliances Security Camera NBC-265-W User Manual

IP Camera 200 Series

Basic Mode | en

Bosch Security Systems

Installation and Operation Manual

AR18-10-B012 | v1.54 | 2011.08

Use the settings on this page to integrate the device into a 

network. Some changes only take effect after a reboot. In this 

case, the Set button changes to Set and Reboot.

1.

Make the desired changes.

2.

Click Set and Reboot.

–

The device is rebooted and the changed settings are 

activated. If the IP address, subnet mask, or gateway 

address is changed, then the device is only available 

under the new addresses after the reboot.

If the network has a DHCP server for dynamic IP address 

allocation, set this parameter to On to activate the automatic 

acceptance of DHCP-assigned IP addresses.

Certain applications (for example, Bosch Video Management 

System) use the IP address for the unique assignment of the 

device. If using these applications, the DHCP server must 

support the fixed assignment between IP address and MAC 

address, and must be appropriately set up so that, once an IP 

address is assigned, it is retained each time the system is 

rebooted.

Enter the desired IP address for the camera. The IP address 

must be valid for the network.

Enter the appropriate subnet mask for the set IP address.

Enter the IP address of the gateway to establish a connection to 

a remote location in a different subnet. Otherwise, this field can 

remain empty (0.0.0.0).