Bosch Appliances Security Camera 5000 User Manual

FLEXIDOME 5000 AN

Connection and set-up | en

Bosch Security Systems

Installation Manual

AM18-Q0648 | v1.0 | 2013.03

The wiring harness has a BNC connector to accept the video 

coax cable (with male BNC connector) and two stripped low 

voltage power wires for connection to a power connector. A 

UTP adapter (VDA-455UTP) is available as an optional accessory 

to allow a UTP video cable to be connected to the BNC 

connector.

The easiest way to connect the cables is as follows:

1.

Bring the building connections through the surface cable 

hole so that they hang clear.

2.

Partially insert two screws into the pre-drilled holes (or 

adapter plate).

3.

Using one of the keyholes, hang the mounting base of the 

camera module on one screw temporarily; tilt the base 

slightly to gain access to the cable connections. 

4.

Connect the BNC connector of the camera module to the 

video coax cable.

5.

Connect the stripped power wires (red +, brown –) to the 

power supply connector.

For a DC supply the polarity is important. Incorrect polarity 

does not damage the camera but it will not switch on. 

6.

In damp environments ensure that the connections are 

sealed. (The surface mounting box and the other mounting 

accessories have a sealed compartment for this purpose.)

7.

Push the connections back through the surface cable hole.

8.

Secure the mounting base of the camera module to the 

surface with three screws.