Bosch Appliances Network Card D8125INV User Manual
D8125INV
Installation
D8125INV Operation and Installation Guide
© 2005 Bosch Security Systems
Page 13
49690E
D7412GV2/D7212GV2/D7412G/D7212G/D7412/D7212
Control Panel
D8125INV
(Points 9-75)
+12v
IN
OUT
GND
+12v
+12v
DATA
GND
FA400 Receiver
Vs GND OUT
To Terminal 3,
AUX Power
AUX Power
To Terminal 9,
Common
Common
FA400 Receiver
Vs GND OUT
Figure 5: D8125INV to D7412GV2/D7212GV2/7412G/D7212G/D7412/D7212 Control Panel Wiring
3.2.1
Setting the Jumper for a second receiver
If the application requires a second FA400 receiver (for example having one receiver on the north side of a large
warehouse and another receiver on the south side of the warehouse), which is typically used for better coverage, follow
the steps below to set up the second FA400 receiver with one D8125INV.
warehouse and another receiver on the south side of the warehouse), which is typically used for better coverage, follow
the steps below to set up the second FA400 receiver with one D8125INV.
To correctly set the jumper on the FA400 receiver, follow the steps below:
1.
Remove the cover of the FA400 receiver.
2.
Locate the jumper switch located above the reset button.
3.
The FA400 Receiver is shipped
with the jumper set for 1 receiver.
with the jumper set for 1 receiver.
1
2
4.
To set the FA400 Receiver to act as
a second receiver, position the
jumper to cover the middle and
right pin.
a second receiver, position the
jumper to cover the middle and
right pin.
1
2
RESET
1
2
RESET
1
2
Note:
If two receivers are being used and the one receiver goes missing, a ‘Receiver Missing’ message will NOT be
reported since the other receiver is still being seen by the D8125INV, however, the points using it will go missing
after the programmed supervision time.
reported since the other receiver is still being seen by the D8125INV, however, the points using it will go missing
after the programmed supervision time.
3.3
D8125INV Quick Startup Recommendations
The following information details the recommended programming steps that should be taken when installing a
D8125INV in a new installation.
D8125INV in a new installation.
1.
Go to Menu 2 and change the Installer Passcode, if necessary (see Section 3.6.2 Menu 2: Change Installer
Passcode, p.23).
Passcode, p.23).
2.
Proceed to Menu 1 to begin adding RF Transmitters to the system (see Section 3.6.1.2 Menu 1: Add, Edit or
Delete RF Transmitter, p.18).
Delete RF Transmitter, p.18).
3.
Use the [DIAG] key for testing the system during and after installation.
3.4
Labeling the Inovonics Transmitters
Prior to programming the Inovonics transmitters or D8125INV, it is recommended that you take the time now to apply
the point number labels from the Point Label Sheet to the individual transmitters.
the point number labels from the Point Label Sheet to the individual transmitters.