Bosch Appliances Network Card D8125INV User Manual
D8125INV
Installation
D8125INV Operation and Installation Guide
49690E
Page 16
© 2005 Bosch Security Systems
3.6
D8125INV Menu Selections
After the passcode is entered and the [ENT] key is pressed, the first of the following menus are displayed with each menu
displayed for three seconds before the next one is displayed.
displayed for three seconds before the next one is displayed.
Figure 14: D8125INV Menu Selections
To select a function, press the corresponding number or function key displayed. This menu scrolls for 5 minutes. After 5
minutes the display returns to showing idle text if no keypad activity is detected.
minutes the display returns to showing idle text if no keypad activity is detected.
It is highly recommended that a walk test be performed after all programming is completed.
3.6.1
Beginning steps to add/edit/delete an RF Transmitter
Follow the steps below to begin the process of adding a new or existing RF transmitter:
1.
From the Idle Text screen, enter the passcode and press
[ENT] to access the main menu.
[ENT] to access the main menu.
2.
Press 1 to add or edit an RF Transmitter (RF Xmtr).
3.
Enter the point number and press [ENT]
4.
At the Transmitter point status screen, do the following depending on the desired action:
To edit mode (see Section 3.6.1.1 Point Mode) and/or check-in time for new transmitters, press 1 and
see Section 3.6.1.3 Adding a new RF Transmitter, p. 18 or to reprogram existing transmitters, see
Section 3.6.1.3 Adding an existing RF Transmitter, p.20.
see Section 3.6.1.3 Adding a new RF Transmitter, p. 18 or to reprogram existing transmitters, see
Section 3.6.1.3 Adding an existing RF Transmitter, p.20.
To delete a transmitter from the D8125INV, press 2 and see Section 3.6.1.4 Deleting an RF Transmitter
p.21.
p.21.