Bosch Appliances Network Card D8125INV User Manual

 D8125INV 

 Installation 

© 2005 Bosch Security Systems 

Page 25 

49690E  

 

3.6.4 

Menu 4: Clear EEPROM 

This menu selection is available if it is believed that the data in the D8125INV is corrupted and you wish to clear the 
information and reprogram it. To clear the EEPROM, follow the steps shown below. 

1. 

To access this menu selection, press 4 from the main menu. The 
keypad will display: 

 

 

followed by:………………………………………………………
 

 

 

 

and then: ………………………………………………………  

 

2. 

Push the [ENT] key. Since clearing the EEPROM will delete the 
entire point database and default the D8125INV to the default 
settings, another confirmation is required to proceed. 

 

3. 

If you wish to exit from this menu, press the [ESC] key. Otherwise, push the [ENT] key one more 
time to confirm that you wish to have the EEPROM erased. 

3.6.5 

Menu 5: Set RF System Supervision Interval 

The RF System Supervision Interval determines how long the D8125INV will wait to hear at least one check-in 
transmission (or any transmission) from a transmitter before sending a Missing condition to the Control Panel. The 
interval value that is chosen applies to all transmitters system wide. To set the RF System Supervision Interval, follow the 
steps shown below. 

 

 

 

 

 

1. 

To access this menu selection, press 5 from the main menu. The 
keypad will then display the following menus: 

<value> = None, 4 hr., 12 hr., or 24 hr.