Bosch Appliances Home Security System DS7400XIV4-EXP User Manual
DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations
EN | 10
Bosch Security Systems | 6/05 | 4998154961B
6.1.4 Custom
Arming
Custom arming is used to arm zones that you specify and your installer programs into your system. An entry/exit
delay is in effect unless otherwise programmed.
delay is in effect unless otherwise programmed.
The green Status LED must be lit and, if using a text keypad, “Ready to Arm” must be displayed. If the green
LED is not on or the keypad displays “Not Ready,” you must use other methods to arm the system (refer to Section
6.2.2 Force Arming on page 13 or Section 6.2.3 Zone Bypass on page 14).
LED is not on or the keypad displays “Not Ready,” you must use other methods to arm the system (refer to Section
6.2.2 Force Arming on page 13 or Section 6.2.3 Zone Bypass on page 14).
Table 6: Custom Arming
Equipment
Command Sequence
What Happens
What To Do
Text Keypad LED
Keypad
Keypad
[PIN][#][4]
• The red Armed LED flashes.
• “On Partial” is displayed. *
• “Exit Now” is displayed during the exit-
delay period. *
• The green Status LED lights steady.
• A single beep sounds.
• The red Armed LED lights steady when
the exit-delay period ends.
• The zones that were programmed for
custom arming are armed.
Exit during the exit-delay
period.
RF3341 Keypad
[PIN][#][4]
• The LED flashes indicating a signal was
sent to your security system.
• The zones programmed for custom
arming are armed.
Exit during the exit-delay
period.
RF3332/RF3332E,
RF3334/RF3334E
RF3334/RF3334E
Not applicable
* Text Keypad only