Bosch SHE4AM User Manual

open the rinse agent dispenser by lifting the tab with your thumb.
NOTE: the dishwasher indicates low rinse agent either by showing the symbol  

 in the 

countdown display, or illuminating the refill rinse agent light (model dependent).
add liquid rinse agent to the dispenser as shown in figure 16 until the rinse agent reservoir 
is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full.
NOTE: After filling the rinse agent dispenser, the  indicator light will go out in a few minutes 
after the dishwasher door is shut (select models only).

Wash Cycles (See Cycle Chart)

always make sure your dishware is dishwasher safe. refer to the 

Dishware Materials 

section of this manual for guidance.

Cleans items having baked-on or hard dried-on food soils. these items may require 
soaking or hand scouring.

Cleans large loads with loosely attached food soils.

thoroughly cleans large loads having loosely attached normal soiling.

for delicate or heirloom dishwasher and silverware or other special items. always make sure 
that the items are dishwasher safe. refer to the Materials section of this manual for further 
information. Hand washing may be the best treatment of such items.

for lightly soiled items with easy to remove food soils.

allows you to rinse the food soil off of a partial load and hold them in the dishwasher until 
there is a full load.

Dishware Drying  

at the end of the cycle the dishwasher will stop and a period of condensation drying will 
follow.  

WARNING

 

- Door must be open. Press the “ON/OFF” button to turn the unit on.
- Wash cycle LED will be flashing to indicate pre-select mode.
- press 

 or 

 to select desired wash cycle. Press the START button (Wash Cycle LED will stop flashing).

- Close the door to start cycle
NOTE: Rinse Agent LED will be illuminated if unit needs rinse agent.