Bosch 2000 User Manual

2000 Series | Program Entry Guide | 5.0 

Remote Programming 

EN | 21 

 

Bosch Security Systems | 7/05 | 35114F 

 

5.0 Remote 

Programming 

Use the prompts in this group to configure your 
system for programming with a Bosch Security 
Systems remote programmer. 

Default: 

999999

 

Selection:  0 to 9, A to F

 

Six characters required. Remote programmers send 
this code to the control panel to gain access to the 
control panel. 

Default: 

Blank

 

Selection:  0 to 9, C, D, #, *, Blank

 

Enter up to nineteen characters for the control panel to 
dial to reach a remote programmer. The 

# and * 

characters are only dialed when the control panel is 
programmed for DTMF dialing. Refer to the 

DTMF 

Dialing 

prompt

 

in

 

 

The control panel 

dials these characters just as if you pressed them on a 
telephone keypad. 

If you program a 

# or * to disable call waiting, warn 

your customer that canceling call waiting service 
requires a change to their security system. 

Programming C produces a 3-second dial delay. 

Programming D produces a 7-second dial tone wait. If 
the control panel detects a dial tone before the 7-
second delay expires, it continues dialing immediately. 

0101
0101
0101

 

 

Remote programming initiated from the 
keypad ([2] key) 

RAM Phone is blank: After you press [2] 
key, the control panel seizes the phone line 
and waits for the remote programmer 
handshake. 

RAM Phone is programmed with a phone 
number: After you press the [2] key, the 
control panel seizes the phone line, dials the 
RAM Phone number, and waits for the 
remote programmer handshake. 

 

Default: 

0

 

Selection:  0 to 15

 

Set the number of rings you want the control 
panel to wait before seizing the phone line for a 
remote programming session when the system is 
All On (armed). 

The control panel cannot seize the phone line 
when the system is All On (armed) if this prompt 
is set to 0 (zero). 

0101
0101
0101

 

 

When Answer Machine is programmed 
Yes, the entry in Answer Armed has no 
affect on the control panel’s operation. 

Default: 

0

 

Selection:  0 to 15

 

Set the number of rings you want the control 
panel to wait before seizing the phone line for a 
remote programming session when the system is 
off (disarmed), Part On, or On with No Delay. 

If this prompt is set to 0 (zero), the control panel 
cannot seize the phone line when the system is off 
(disarmed), Part On, or On with No Delay. 

0101
0101
0101

 

 

When Answer Machine is programmed 
Yes, the entry in Answer Disarmed has no 
affect on the control panel’s operation. 

Default: 

0

 

Selection:  0 to 15

 

Set this prompt to Yes to enable the Answering 
Machine Bypass feature. 

When 

Answer Machine

 is programmed Yes, you 

must set the answering machine to pick up the 
phone on four or more rings. This feature does not 
work if the answering machine picks up the phone 
after one ring. 

When 

Answer Machine 

is programmed Yes, the 

control panel picks up the phone for a remote 
programming session if it detects the following 
events listed in Table 4.