Bosch 3924-24 User Manual

1.

Lift the miter detent trigger 

1 (Figure 24).

2.

Push the detent override clip 

2 forward and latch in place

over edge. Release miter detent trigger 

1.

3.

Move miter arm 

3 to any position on the miter scale.

4.

Lock the miter lock knob 

4 to retain miter position.

5.

Loosen miter lock knob 

4 and lift the miter detent trigger

1 to release the detent override clip 2.

Extend and use sliding base/fence when
making severe bevel, severe miter or

compound cuts to provide sufficient (minimum 6”) spacing
from hand to saw blade.

1.

Remove hex wrench from storage position on left rear
leg.

2.

Loosen two (2) socket cap screws 

5 in sliding base

channel with the 6 mm hex wrench provided (Figure 25).

3.

Extend sliding base/fence 

6 to the desired position.

4.

Tighten screws.  Store hex wrench.

1.

Unlock the fence locking lever 

7 (Figure 26).

2.

Slide fence to proper position 

8.

3.

Relock fence in place.

During transportation, sliding base and
fence should always be secured in the full

in position.

50

45

40