Bogen BOGEN M300 User Manual

Two input module bays are available to accept various Bogen input modules thereby allowing users to customize
the amplifier to suit the needs of the installation. Read the instructions included with the module and
make the desired jumper setting changes before installing the module. The sleep switch should be
set to the desired position prior to installation of the right module since it will be covered by the module (see
Operation, Sleep Mode Defeat).
The input modules are installed by simply sliding them along the card guides inside the module bays until the
faceplate firmly sits against the M-Class chassis, then use the two screws supplied with the module to secure it
to the chassis.

Note: The input module included with the amplifier is pre-installed and factory set for 0 dB gain (can 

also be changed to 18 dB boost) and to be muted by any other module (can also be set to “no 
mute”).To change those settings, refer to the manual included with the module.

6