Bogen 54-2141-01B 0608 User Manual
Transmitter Setup
Unscrew and remove the Battery Compartment
Cover (1) by sliding it down off the microphone to
expose the battery holder. Insert 2 fresh AA alkaline
batteries or the optional BCHRBP Battery Pack NiMH
rechargeable batteries, while observing the correct
polarity as marked, and screw the cover back on the
battery compartment. (Note: Make sure the transmitter is
OFF when changing the batteries.)
Unscrew and remove the Battery Compartment
Cover (1) by sliding it down off the microphone to
expose the battery holder. Insert 2 fresh AA alkaline
batteries or the optional BCHRBP Battery Pack NiMH
rechargeable batteries, while observing the correct
polarity as marked, and screw the cover back on the
battery compartment. (Note: Make sure the transmitter is
OFF when changing the batteries.)
Operation
Slide the Power Switch (2) to the ON position. The
Power LED Indicator (3) will light green, indicating that
the transmitter is ON. In the case of dead batteries, the
indicator will be off, indicating that the alkaline batteries
should be replaced with fresh ones or that the BCHRBP
Battery Pack should be recharged. (Note: The optional
Battery Pack should only be charged with the BCBC Charger
listed. Never attempt to recharge alkaline batteries.) The BCBC can also be used to recharge two BCWHT
Handheld Microphones simultaneously. When the microphone is placed in the recharging adapter, the
recharger’s LED Indicator will light bright red. The LED Indicator will light green when the batteries are
charged. (Note: Always remove batteries from the BCWHT microphone when not in use.)
Slide the Power Switch (2) to the ON position. The
Power LED Indicator (3) will light green, indicating that
the transmitter is ON. In the case of dead batteries, the
indicator will be off, indicating that the alkaline batteries
should be replaced with fresh ones or that the BCHRBP
Battery Pack should be recharged. (Note: The optional
Battery Pack should only be charged with the BCBC Charger
listed. Never attempt to recharge alkaline batteries.) The BCBC can also be used to recharge two BCWHT
Handheld Microphones simultaneously. When the microphone is placed in the recharging adapter, the
recharger’s LED Indicator will light bright red. The LED Indicator will light green when the batteries are
charged. (Note: Always remove batteries from the BCWHT microphone when not in use.)
The microphone is now ready to use. The BCWR receiver IR LED Indicator of the corresponding channel
should now be lit green. While speaking into the microphone, adjust the corresponding Volume Control
on the receiver and also on your Mixer/P.A. to the desired level. For optimum performance and range,
make sure that the IR emitter at the base of the transmitter is not covered by the hand and has an unob-
structed line-of-sight with the IR sensor.
should now be lit green. While speaking into the microphone, adjust the corresponding Volume Control
on the receiver and also on your Mixer/P.A. to the desired level. For optimum performance and range,
make sure that the IR emitter at the base of the transmitter is not covered by the hand and has an unob-
structed line-of-sight with the IR sensor.
Note: Observe care in selecting volume, transmitter location and speaker placement so that acoustic feedback
(howling and screeching) will be avoided.
(howling and screeching) will be avoided.
BCWHT Handheld Microphone Transmitter
1
2
3
9
1
2
3