BMW K 1100 LT/RS User Manual
23.28
Re-assembling motorcycle
•
Install battery.
•
Intall Motronic control unit.
•
[ABS II] Install ABS unit.
•
Install battery.
•
Intall Motronic control unit.
•
[ABS I] Install control unit.
•
Install swinging arm.
•
Install footrest plates.
•
[ABS I] Install pressure modulators.
•
Install rear wheel drive.
•
Install suspension strut.
•
Install rear wheel.
•
Install brake caliper
L
Note:
Check ABS sensor gap.
•
Install exhaust system.
•
Install rear mudguard.
•
Install side section of fairing.
X
Tightening torques:
Fixed swinging arm bearing at geabox ........... 8 Nm
Fixed swinging arm bearing journal,
free bearing ................................................. 7.5 Nm
Locknut, free bearing ................................... 41 Nm
Bearing pin of fixed bearing ....................... 150 Nm
(clean thread + Loctite 2701)
Bearing pin of loose bearing .......................... 7 Nm
(clean thread + Loctite 2701 applied to entire
length of thread on loose bearing pin)
Locknut ...................................................... 105 Nm
Suspension strut to frame/rear wheel drive .. 51 Nm
Rear wheel studs ....................................... 105 Nm
Exhaust pipes to cylinder head .................... 21 Nm
Exhaust system to holder/footrest plate ......... 9 Nm
Front silencer (muffler) to gearbox ................ 12 Nm
Footrest plate to gearbox ............................. 15 Nm
Fixed swinging arm bearing journal,
free bearing ................................................. 7.5 Nm
Locknut, free bearing ................................... 41 Nm
Bearing pin of fixed bearing ....................... 150 Nm
(clean thread + Loctite 2701)
Bearing pin of loose bearing .......................... 7 Nm
(clean thread + Loctite 2701 applied to entire
length of thread on loose bearing pin)
Locknut ...................................................... 105 Nm
Suspension strut to frame/rear wheel drive .. 51 Nm
Rear wheel studs ....................................... 105 Nm
Exhaust pipes to cylinder head .................... 21 Nm
Exhaust system to holder/footrest plate ......... 9 Nm
Front silencer (muffler) to gearbox ................ 12 Nm
Footrest plate to gearbox ............................. 15 Nm