BMW K 1100 LT/RS User Manual
33.21
Installing swinging arm
•
Slide swinging arm over drive shaft.
•
Lift drive shaft over the support surface in the
swinging fork and press forward swinging arm as
far as possible until gaiter snaps in position at the
gearbox neck.
swinging fork and press forward swinging arm as
far as possible until gaiter snaps in position at the
gearbox neck.
•
Coat bearing pin of fixed bearing with
Optimoly TA
and install and firmly tighten with
special tool
BMW No. 26 1 660
.
•
Install bracket (1) for line of electric side stand
switch.
switch.
X
Tightening torque:
Swinging arm fixed bearing ............................ 9 Nm
•
Coat bearing pin of loose bearing with
Optimoly TA, install, firmly tighten and secure
locknut.
Optimoly TA, install, firmly tighten and secure
locknut.
X
Tightening torques:
Bearing pin of loose bearing
(clean thread + Loctite 270)............................ 7 Nm
Locknut ........................................................ 41 Nm
(clean thread + Loctite 270)............................ 7 Nm
Locknut ........................................................ 41 Nm
Installing footrest plates
•
Install left footrest plate.
•
[ABS]
Note earth (ground) cable.
•
Mount silencer.
X
Tightening torques:
Footrest plate to gearbox ............................ 15 Nm
Silencer to footrest plate ................................ 9 Nm
Silencer to footrest plate ................................ 9 Nm
•
Install right footrest plate.
•
Carefully arrange all leads and hoses; ensure
they are not pinched.
they are not pinched.
•
[ABS] Note earth (ground) cable.
X
Tightening torques:
Footrest plate to gearbox ............................. 15 Nm
[ABS I] Support bracket,
pressure modulator ...................................... 17 Nm
[ABS I] Support bracket,
pressure modulator ...................................... 17 Nm
26 1 660
LT330310
LT330390
1