BMW K 1100 LT/RS User Manual
11.35
Assembling the crankcase
•
Install O-rings (6,7) for the water and oil passag-
es.
es.
•
Coat the sealing faces (which must be free from
oil and grease) lightly with 3-Bond-1209.
oil and grease) lightly with 3-Bond-1209.
•
Place the two halves of the housing together.
•
Screw in bearing bolts (4, 5) for the shouldered
and needle roller bearings, and tighten alternate-
ly.
and needle roller bearings, and tighten alternate-
ly.
X
Tightening torques:
Shouldered bearing (4) ................................. 40 Nm
Needle roller bearing (5) ............................... 18 Nm
Retaining screws of two halves of the housing7 Nm
Needle roller bearing (5) ............................... 18 Nm
Retaining screws of two halves of the housing7 Nm
1
2
3
4
5
LT110530
6
7
KR110521
Installing oil mesh strainer
•
Note presence of O-ring (2).
Installing oil filter
•
Coat the oil filter sealing ring with oil.
•
Do not tighten the oil filter more than half a turn
beyond the point where it makes contact.
beyond the point where it makes contact.
Installing oil sump
•
Coat the sealing faces (which must be free from
oil and grease) with 3-Bond 1209.
oil and grease) with 3-Bond 1209.
X
Tightening torques:
Retaining screws............................................ 7 Nm
Oil filter......................................................... 11 Nm
Oil filter......................................................... 11 Nm