Black & Decker LSW36B User Manual

Page of 36
5
authorized service center.
•  Do not disassemble charger; take it to an authorized service 
center when service or repair is required. Incorrect reassembly may 
result in a risk of electric shock, electrocution or fire.
•  Disconnect the charger from the outlet before attempting any 
cleaning. This will reduce the risk of electric shock. Removing the 
battery pack will not reduce this risk.
•  NEVER attempt to connect 2 chargers together.
•  The charger is designed to operate on standard household electrical 
power (120 Volts). Do not attempt to use it on any other voltage. 
SAVE THESE INSTRUCTIONS    
IMPORTANT SAFETy INSTRUCTIONS                        
FOR BATTERy PACkS
WARNING:
 
For safe operation, read this manual and manuals 
originally supplied with tool before using the charger.
The battery pack is not fully charged out of the carton. Before using the battery 
pack and charger, read the safety instructions below. Then follow charging 
procedures outlined.
READ ALL INSTRUCTIONS
•  Do not incinerate the battery pack even if it is severely damaged or is 
completely worn out. The battery pack can explode in a fire. Toxic fumes 
and materials are created when battery packs are burned.
•  Do not charge or use battery in explosive atmospheres, such as 
in the presence of flammable liquids, gases or dust. Inserting or 
removing the battery from the charger may ignite the dust or fumes.
•  If battery contents come into contact with the skin, immediately wash 
area with mild soap and water. If battery liquid gets into the eye, rinse water 
over the open eye for 15 minutes or until irritation ceases. If medical attention 
is needed, the battery electrolyte for Li-ion batteries is composed of a mixture 
of liquid organic carbonates and lithium salts.
•  Contents of opened battery cells may cause respiratory irritation. 
Provide fresh air. If symptoms persist, seek medical attention.
•  Do not expose charger to rain or snow.
•  Pull by plug rather than cord when disconnecting charger. 
This will reduce risk of damage to electric plug and cord.
•  Make sure that cord is located so that it will not be stepped 
on, tripped over, or otherwise subjected to damage or stress.
•  Do not use an extension cord unless it is absolutely 
necessary. Use of improper extension cord could result in risk of 
fire, electric shock, or electrocution.
•  Do not place any object on top of charger or place the charger 
on a soft surface that might block the ventilation slots and 
result in excessive internal heat. Place the charger in a 
position away from any heat source. The charger is ventilated 
through slots in the top and the bottom of the housing.
•  Do not mount charger on wall or permanently affix charger 
to any surface. The charger is intended to use on a flat, stable 
surface (i.e., table top, bench top).
•  Do not use with damaged cord or plug. If appliance is not working 
as it should, has been dropped, damaged, left outdoors, or dropped 
into water, return it to a service center.
•  Do not pull or carry by cord, use cord as a handle, close a door 
on cord, or pull cord around sharp edges or corners. Do not run 
appliance over cord. Keep cord away from heated surfaces.
•  Do not operate charger with damaged cord or plug — have 
them replaced immediately.
•  Do not operate charger if it has received a sharp blow, been 
dropped, or otherwise damaged in any way. Take it to an 
Minimum Gauge for Cord Sets
 Volts 
Total Length of Cord in Feet
 120V 
0-25  26-50  51-100  101-150
 240V 
0-50  51-100  101-200  201-300
 Ampere Rating 
 More Not more 
American Wire Gauge
 Than Than
 0  -  6 
18 
16 
16 
14
 6  -  10 
18 
16 
14 
12
 10  -  12 
16 
16 
14 
12
 12  -  16 
14 
12 
Not Recommended