Bixolon Receipt Printer SRP-270 User Manual

 

8-8-3 Adjustment 
 
When assembling this printer, be sure to refer to the required adjustment procedure. 
To ensure normal operation of the printer after disassembly or replacement of a Component for maintenance 
or repair. Be sure to perform along to the required method. 
 
* Adjustment of Head gap 
 
Adjustment 

Step 

Description Points 

in Adjustment 

1 

 
 

2 

 
 
 
 
 
 
 

 
 

 
 
 
 
 
 

3 

 
 

4 

• Rotate Gear lst Reduction to move the Head unit 

to L side. 

 
• Insert the thickness gauge between Head unit and 

Platen, then rotate the Ad. 
Level L and adjust the gap. 

 

 

 
• Move the Head unit then check if the proper 

gap from R side center has been achieved. 

 
• If Head gap is not proper, adjust Head gap by 

rotating Ad.Lever R. 

 
 
 
- Appropriate gap: 0.50~0.60mm 
 
 
 
 
 
 
- In order to make the gap narrow 

(wide), turn Ad. 
Lever to mark ’-(+)’ 

 
 
 

 
 

 
 
 
 
- If gap is not correct, repeat once 

more. 

 

(Replacement of Head unit) 

 
 
 
 
Follow below steps for replacing Head unit 
 
1. Loosen the Ribbon frame 
 
2. Disassemble the Head unit from the Head Carriage and take out the Head FPC from the connector of 

PCB Assy. 

 
4. Replace the Head unit and assemble, according to the order of sub Aassy-1 
 
5. After assembling, adjust the gap as above “Adjustment” indicates. 
 
6. Assemble the Ribbon Frame.