Bissell ProHeat 2X 9500-P Leaflet

BISSELL is happy to be of service. 

Contact us directly at 1-800-237-7691 or

visit the website for helpful instructions at

Quick Start

Guide

BISSELL Homecare, Inc.
P.O. Box 1888
Grand Rapids, MI 49501

© 2012 BISSELL Homecare, Inc. 

a.  Machine Base & 2 tank system
b.  Upper Handle
c.  4 Screws - taped to handle 
d.  Upper Hose Rack
e.  Lower Hose Rack

f. Formula
g.  TurboBrush® Tool
h.  2-in-1 Crevice Tool
i.   6-Inch Stair Tool

1.  While pressing the trigger, make one slow forward  

wet pass and another one back 

2.  Release the trigger and make one slow forward  

and backward pass over the same area. Repeated  

passes will help aid in dry time 

3.  Continue passes until cleaning area is complete 
4.  When the dirty water reaches the “FULL” line on the tank,  

it is time to empty 

5.  Empty dirty water by removing tank from base of machine.  

Carry to sink or outside to dispose of water. Unlatch top of  

tank and pour dirty water through triangle shaped opening in corner

6.  Refill as needed, following steps 4 & 5 under "Before you begin cleaning"

1.  Fill the formula tank to "WATER" line with water. Fill to  

"FORMULA" line with BISSELL 2X Hard Floor Solutions.

2.  Attach the bare floor tool onto the bottom of the  

machine by hooking it into the nozzle and swinging  

it down until it clicks into place.

3.  Slowly move the machine forward and back over hard floor surface one 

time while depressing trigger.  Caution:  Do not overwet.

4.  Repeat the motion without pressing the trigger to suction up the dirty water.
5.  When the dirty water reaches the “FULL” line on the tank, follow instruction 

#5 under “Carpet Cleaning” to empty tank

6.  When cleaning is complete, remove and rinse tool in warm water 
7.  Allow adequate time for floors to dry.

1.  Set ReadyTools dial to the “TOOLS” setting    
2.  Attach the cleaning tool to the end of the hose
3.  Clean by pressing the trigger to spray solution  

onto the area to be cleaned

4.  Slowly scrub the tool back and forth over the soiled surface
5.  Tilt the tool forward to suction liquid
6.  Follow steps 5 & 6 under "Bare Floor cleaning"

Refer to the enclosed user guide for complete 

instructions and important safety notices.

120-4493