Manualsbrain.com
  1. Manuals
  2. Brands
  3. Biostar
  4. TP43E3 XE
  5. Owner's Manual

Biostar TP43E3 XE Owner's Manual

Download
Page of 59
TP43E3 XE 
23 
 
Notices: 
Not all types of Intel CPU perform above overclock setting ideally; the difference will be based on the 
selected CPU model. 
B. Memory Integration Test (M.I.T.) 
This function is under “Overclocking Navigator Engine” item. 
MIT allows users to test memory compatibilities, and no extra devices or 
software are needed. 
Step 1 
The default setting under this item is “Disabled”; the condition parameter should 
be changed to “Enable” to proceed this test. 
BIOS SETUP UTILITY
Main
Advanced
PCIPnP
Boot
Chipset
O.N.E
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Select Screen
Select Item
Go  to Sub Screen
General Help
Save and Exit
Exit
Enter
F1
F10
ESC
Over-Clocking Navigator  setting
=========== Automate OverClock System  ===========
============ Manual OverClock System ============
WARNING:
Please Clear CMOS  if system  no display
after overclocking.
Over-Clocking Navigator            [Normal]
Auto OverClock System          [V6-Tech Engine]
Intel(R) SpeedStep(tm) tech    [Enabled]
Ratio CMOS  Setting                   [ x8.0]
CPU Frequency Setting               [266]
Over Clock Retry Count         [3]
FSB(Bsel) To  NorthBridge Latch [Auto]
DRAM Frequency                 [Auto]
Enhanced  Mode                          [Auto]
> DRAM Timing Configuration
> Clock Gen    Configuration
> Voltage Configuration
> G.P.U Phase Control
Memory  Test                             [Disabled]
Exit
       Options
Disabled
Enabled
 
↓ 
BIOS SETUP UTILITY
Main
Advanced
PCIPnP
Boot
Chipset
O.N.E
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Select Screen
Select Item
Go  to Sub Screen
General Help
Save and Exit
Exit
Enter
F1
F10
ESC
Over-Clocking Navigator  setting
=========== Automate OverClock System  ===========
============ Manual OverClock System ============
WARNING:
Please Clear CMOS  if system  no display
after overclocking.
Over-Clocking Navigator            [Normal]
Auto OverClock System          [V6-Tech Engine]
Intel(R) SpeedStep(tm) tech    [Enabled]
Ratio CMOS  Setting                   [ x8.0]
CPU Frequency Setting               [266]
Over Clock Retry Count         [3]
FSB(Bsel) To  NorthBridge Latch [Auto]
DRAM Frequency                 [Auto]
Enhanced  Mode                          [Auto]
> DRAM Timing Configuration
> Clock Gen    Configuration
> Voltage Configuration
> G.P.U Phase Control
Memory  Test                             [Enabled]
Exit
       Options
Disabled
Enabled
 
Step 2 
Save and Exit from CMOS setup and reboot the system to activate this test.   
Run this test for 5 minutes (minimum) to ensure the memory stability. 
Step 3 
When the process is done, change the setting back from “Enable” to “Disable” 
to complete the test.