Beko WM74135W Installation Instruction

24

EN

Service life of the product extends and 

frequently faced problems decrease if 

cleaned at regular intervals.

Clean the detergent drawer at regular 

intervals (every 4-5 washing cycles) 

as shown below in order to prevent 

accumulation of powder detergent in 

time.

1.  Press the dotted point on the siphon 

in the softener compartment and pull 

towards you until the compartment is 

removed from the machine.

C

 If more than normal amount of water 

and softener mixture starts to gather 

in the softener compartment, the 

siphon must be cleaned.

2.  Wash the detergent drawer and the 

siphon with plenty of lukewarm water 

in a washbasin. Wear protective 

gloves or use an appropriate brush to 

avoid touching of the residues in the 

drawer with your skin when cleaning.

3.  Insert the drawer back into its place 

after cleaning and make sure that it is 

seated well.

Residues of softener, detergent and 

dirt may accumulate in your machine in 

time and may cause unpleasant odours 

and washing complaints. To avoid this, 

use the Drum Cleaning programme. If 

your machine is not featured with Drum 

Cleaning programme, use Cottons-90 

programme and select Additional Water 

or Extra Rinse auxiliary functions as well. 

Before starting the programme, put 

max. 100 g of powder anti-limescale into 

the main wash detergent compartment 

(compartment nr. II). If the anti-limescale 

is in tablet form, put only one tablet into 

compartment nr. II. Dry the inside of the 

bellow with a clean piece of cloth after the 

programme has come to an end. 

C

 Repeat Drum Cleaning process in 

every 2 months.

C

 Use an anti-limescale suitable for the 

washing machines. 

After every washing make sure that no 

foreign substance is left in the drum.

If the holes on the bellow shown in the 

figure is blocked, open the holes using a 

toothpick.

C

 Foreign metal substances in your 

machine will cause rust stains. Clean 

the stains on the drum surface by 

using cleaning agents for stainless 

steel. Never use steel wool or wire 

wool.

Wipe the body of the machine with 

soapy water or non-corrosive mild gel 

detergents as necessary, and dry with a 

soft cloth.

Use only a soft and damp cloth to clean 

the control panel.

A

 Never use sponge or scrub materials. 

These will damage the painted and 

plastic surfaces.

There is a filter at the end of each water 

intake valve at the rear of the machine 

and also at the end of each water 

intake hose where they are connected 

to the tap. These filters prevent foreign 

substances and dirt in the water to enter 

the washing machine. Filters should be 

cleaned as they do get dirty.