Behringer Xenyx X2222USB Owner's Manual

XENYX X2442USB/X2222USB/X1832USB/X1622USB User Manual

SERIAL NUMBER
Please note the important information on the serial number given in 

chapter 1.3.3.

The packaging of your mixing console contains two 19" rack mounts for 

installation on the side panels of the console.
Before you can attach the rack mounts to the mixing console, you need to remove 

the screws holding the left and right side panels. Then, use these screws to 

fasten the two rack mounts, each specifically to one side. With the rack mounts 

installed, you can mount the mixing console in a commercially available 19" rack. 

Be sure to allow for proper air flow around the unit, and do not place the mixing 

console close to radiators or power amps, so as to avoid overheating.

You will need a large number of cables for the various connections of the console. 

The illustrations below show the wiring of these cables. Be sure to use only high-

grade cables.

The footswitch connects both poles momentarily

Fig. 6.1: Foot switch connector

6.2.1  Audio connections
Please use commercial RCA cables to wire the 2-track inputs and outputs.
You can, of course, also connect unbalanced devices to the balanced input/

outputs. Use either mono plugs, or use stereo plugs to link the ring and shaft (or 

pins 1 & 3 in the case of XLR connectors).

For unbalanced use, pin 1 and pin 3 

have to be bridged

1 = ground/shield

2 = hot (+ve)

3 = cold (-ve)

1

2

3

1

2

3

Fig. 6.2: XLR connections

Fig. 6.3: ¼" mono plug

For connection of balanced and unbalanced plugs,

ring and sleeve have to be bridged at the stereo plug.

Fig. 6.4: ¼" stereo plug