Behringer Minimon MON800 User Manual
10
MINIMON MON800 User Manual
5. Audio Connections
There are various ways to integrate the MON800 into your set-up.
Depending on the application in question, you will need different sets
of connecting cables. The cables to use are described below.
Depending on the application in question, you will need different sets
of connecting cables. The cables to use are described below.
5.1 Connection with 1/4" or cinch cables
Please use standard 1/4" or cinch cables to connect the MINIMON to
other equipment. These cables have a 1/4" or cinch connector at each
end. Connect the inputs and outputs of the MON800 to the respective
connectors of the other devices.
other equipment. These cables have a 1/4" or cinch connector at each
end. Connect the inputs and outputs of the MON800 to the respective
connectors of the other devices.
shield
sleeve
sleeve
tip
tip
Fig. 5.1: Wiring diagram of a hi-fi cinch cable
strain relief clamp
strain relief clamp
sleeve
sleeve
tip
tip
sleeve
ground/shield
sleeve
ground/shield
tip
signal
tip
signal
Fig. 5.2: Unbalanced cable with 1/4" TS connectors
5.2 Footswitch connection
The MINIMON features a jack for the connection of a footswitch.
Here, you can connect any commercially available footswitch with
a 1/4" TS connector. As some footswitch models on the market have
a different polarity, please be sure to use one that is appropriately
wired. The correct wiring is shown in the illustration below.
Here, you can connect any commercially available footswitch with
a 1/4" TS connector. As some footswitch models on the market have
a different polarity, please be sure to use one that is appropriately
wired. The correct wiring is shown in the illustration below.
strain relief clamp
sleeve
sleeve
tip
sleeve
pole 1/ground
tip
pole 2
The footswitch connects both poles momentarily
¼" TS footswitch connector
Fig. 5.3: Wiring of a 1/4" TS connector for footswitch connection
5.3 Headphones connection
The MINIMON has two jacks for headphones. Here, you can connect
any standard pair of stereo headphones with a 1/4" TRS connector.
For 3.5-mm plugs you need an appropriate adaptor. The correct
wiring diagram is shown in the illustration below.
any standard pair of stereo headphones with a 1/4" TRS connector.
For 3.5-mm plugs you need an appropriate adaptor. The correct
wiring diagram is shown in the illustration below.
strain relief clamp
sleeve
ring
tip
ring
tip
sleeve
ground/shield
¼" TRS headphones connector
ring
right signal
tip
tip
left signal
Fig. 5.4: Wiring of a 1/4" TRS headphones connector