Behringer Europower PMP1000 Owner's Manual

EUROPOWER PMP6000/PMP4000/PMP1000 User Manual

4. Installation

4.1 Mains connection

The mains connection is made using the enclosed power cord and a standard IEC

receptacle. It meets all of the international safety certification requirements.
Blown fuses must be replaced by fuses of the same type and rating.

◊

Please make sure that all units have a proper ground connection.
For your own safety, never remove or disable the ground conductor
from the unit or of the AC power cord.

4.2 Audio connections

The inputs and outputs of your BEHRINGER EUROPOWER are unbalanced 1/4" mono

jacks—except for the mono channel line inputs, which are balanced 1/4" stereo

jacks. Of course, all inputs and outputs work with both balanced and unbalanced

connectors. The tape in and outputs are on RCA connectors.

◊

Please ensure that only qualified personnel install and operate the
PMP. During installation and operation, the user must have sufficient
electrical contact to earth. Electrostatic charges might affect the
operation of the unit.

strain relief clamp

sleeve

tip

sleeve

(ground/shield)

Unbalanced ¼" TS connector

tip

(signal)

Fig. 4.1: 1/4" TS connector

strain relief clamp
sleeve
ring
tip

sleeve

ground/shield

For connection of balanced and unbalanced plugs,

ring and sleeve have to be bridged at the stereo plug.

Balanced ¼" TRS connector

ring

cold (-ve)
tip

hot (+ve)

Fig. 4.2: 1/4" TRS connector

output

For unbalanced use, pin 1 and pin 3

have to be bridged

1 = ground/shield

2 = hot (+ve)

3 = cold (-ve)

input

Balanced use with XLR connectors

Fig. 4.3: XLR connectors

strain relief clamp

sleeve
ring
tip

sleeve

ground/shield

¼" TRS footswitch connector

ring

FX2
tip

FX1

Fig. 4.4: 1/4" mono plug for footswitch

strain relief clamp
sleeve
ring
tip

sleeve

ground/shield

Connect the insert send with the input and the insert with

the output of the output effects device.

Power amp insert send return ¼" TRS connector

ring

send (out)
tip

return (in)

Fig. 4.5: Stereo 1/4" TRS connector for power amp ISR connection