LG D1454TF Owner's Manual

■

Fill the regenerating salt container 

before starting the washing programme. 

Once you have filled with salt you must run the 

Quick course immediately to remove salt and salt 

water around the tub in order to prevent corrosion.
• Remove lower rack and unscrew the cap of salt container.
•    Before using your dishwasher for the first time, it is necessary  

to 

Pour 1.5kg of salt and 1 litre of water in to the container.                                  

Otherwise salt refill lamp always turn on during operation. 

Use a funnel for ease and clean filling, ensuring that coarse salt  

or regenerating salt intended for dishwashers is used.

•  After filling, wipe off any spilled salt to seal the cap properly.
•  Screw the cap tightly to prevent any suds from penetrating into  

the container.

In order to provide satisfactory rinsing results, the dishwasher requires soft water, i.e., containing 

little or no lime, otherwise water stains will be left behind on the dishes and interior containers.

If the tap water exceeds a certain level of hardness, it must be softened, I.e.,decalcified.

This is achieved by adding a special salt to the water softener inside the dishwasher.

The required amount of salt is set up according to how hard your tap water is.

■

To fill the Rinse Aid chamber, push the rinse aid button. Fill the container to the maximum level 

with a good quality Rinse Aid, then close the cap. 

The Rinse Aid is automatically dispensed during the final rinse cycle.

The dosage is factory set to suit most installations. If, after washing, you notice cloudy spots, 

streaks or water marks on your glassware, it may be necessary to increase the setting. To do this, 

remove the cap and rotate the indicator arrow to a higher setting then replace the cap . If the glass 

is smeared or foam is present on the bottom of the glass or the bottom of the machine, select a 

lower setting.