Barco DICOM THEATER MGP 15 User Manual
Controlling the projector
85
Controlling the projector
Introduction
The projector control provides quick access to some frequently
used projector functionality, such as:
used projector functionality, such as:
•
Source selection: Allows fast switching between projector
inputs. Only inputs that have a valid input (a valid signal
present at the input) will be selectable.
inputs. Only inputs that have a valid input (a valid signal
present at the input) will be selectable.
•
Picture-in-picture: Allows fast switching between different
picture-in-picture layouts.
picture-in-picture layouts.
•
Projector status: Allows the user to put the projector in
different on/off states.
different on/off states.
The projector control view allows the user to address the
different projectors in the configuration. Each projector is
represented by a tab. So whenever a command is executed, the
projector that is represented by the current tab is addressed.
different projectors in the configuration. Each projector is
represented by a tab. So whenever a command is executed, the
projector that is represented by the current tab is addressed.
The last tab in the view, Configuration, allows customization of
the other projector tabs.
the other projector tabs.
Note: The "Projector Control" item in the main popup menu is
enabled only when connection to the projector is possible. If the
projector could not be detected, the item is disabled
enabled only when connection to the projector is possible. If the
projector could not be detected, the item is disabled
Source selection
To switch sources, proceed as follows:
1. Position the cursor over the Dicom Theater sys-tray icon and
click the right mouse button (“right-click”).
The Dicom Theater menu appears.
2. Click Projector Control.
The projector control view appears.
3. Click the tab of the projector you wish to control.