Barco DICOM THEATER LITE MGP D5 User Manual

Windows 2000 BarcoMed 2MP2CP software installation

MGP D5 Dicom Theater Lite

37

Windows 2000 BarcoMed 2MP2CP software installation

Note: These instructions apply to both Windows

®

2000 and 

®

XP.

Preparation

Prior to installing your MGP D5 Dicom Theater software the 
following should be done.

1. Install the BarcoMed 2MP2CP display controller(s) in your 

system.

2. Connect the MGP D5 Dicom Theater projector and display 

panel(s) (if any) to the BarcoMed 2MP2CP display 
controller(s) and power supply(s).

3. Decide if you want to install the Barco DPMS Screen Saver 

Software in addition to the driver. (See “Barco DPMS Screen 
Saver” on page 65 for a description of this add-on feature.)

4. Decide if you are going to install the BarcoMed 2MP2CP 

driver with “Cloned Heads active” mode enabled or disabled 
(DualView). When “Cloned Heads” is selected, the second 
head is identical to the first head. When DualView is 
selected, each head is completely independent.  

Using the BarcoMed product installation wizard

To install your BarcoMed 2MP2CP Windows display controller 
driver and the Barco DPMS Screen Saver Software for the first 
time follow the steps below.

If you are reinstalling the drivers or installing a new driver 
release over an existing driver release you may skip steps 2 and 
3 below: 

1. Boot your system, and log in using an account with 

administrator privileges. 

2. For each BarcoMed 2MP2CP display controller installed in 

your system Windows will launch the “Found New Hardware 
Wizard”. Click “Cancel”. Continue to click “Cancel” until