BT PowerGrid 902 User Manual

5

Comtrend’s PG902 starter kit, supplied in pairs, comes ready to use; 

the Powerline adapters are paired in our factory so they will recognize 

each other, which makes setup this easy: 

. Plug both PG902 adapters into an electrical socket 

a. One next your router (or modem)
b. One next to the device you will connect to your network

2. The Status LEDs on both PG902 adapters will light up RED
3. When the Status LEDs are both GREEN the adapters are ready 

to use

Pick the PG902 adapter with a serial number ending with the letter “A”.  

The serial number can be found on the label at the back of the adapter.  

This is the Access Point (AP).  Connect the AP to your router with an 

Ethernet cable, as shown here.

Connect  the  other  PG902  to  your  computer,  V-box  or  other  network 

device using an Ethernet cable.  This is the End Point (EP).

260072-021_PG902_User_Guide(UK_A5   5

2008/8/6   �� 10:44:49