Bosch 4100 User Manual

If table saw is to be used in a permanent location, it should be
fastened securely to a firm supporting surface such as a stand or
workbench, using the four mounting holes 

6 (Fig. 15).

1. If mounting to a workbench, the base should be bolted

securely using 5/16" hex bolts (not included) through mounting
holes 

6. 

Hint: If workbench is 3/4” thick, bolts will have to be at least
3-1/2” long - if workbench is 1-1/2” thick, bolts should be at
least 4-1/2” long.

2. Locate and mark where the saw is to be mounted, relative to

holes in the base of the tool.

3. Drill four (4) 3/8" diameter holes through workbench.

4. Place table saw on workbench aligning holes in base with

holes drilled in workbench.

5. Insert four (4) 5/16" dia. bolts through holes in base and

supporting surface; then secure with (4) 5/16” flat washers and
(4) 5/16" hex nuts.

1. Raise rip fence handle 

1, so holding clamp 2 is out far enough to

fit on the table 

3 and into “V” groove located on the back of rear

rail (Fig. 14).

2. Position the rip fence 

4 over table 3 holding up the front 

end, first engage holding clamp 

2 with rear rail.

3. Lower front end onto front rail 

5.