Bosch Appliances Radio LE10 User Manual

en | Operation

LE10 Radio Receiver

F.01U.278.517 | V2.0 | 2012.11

User Manual

Bosch Security Systems

Battery-low indication:

–

Relay 2 switches on for 2 seconds.

–

The red LED flashes for 2 seconds, then blinks 1 second

every 10 seconds.

For all MIYS35 and MIYS37 transmitters, the battery low status

is triggered when the transmitter is activated or with the daily

message. For all MIYN46 transmitters, the battery low status is

triggered only with the daily message.

6.9

Dual channel receiver (mode 9, only with
SW 1.10)

Programming and deleting of transmitters is done as in Mode 1.

Standby

–

The green LED stays permanently on.

–

The red LED is off.

–

Relay 1 is switched off.

–

Relay 2 is switched off.

When a transmitter, that is matched on a odd position (1, 3, 5,

etc.), is activated:

–

Relay 1 switches on for 2 seconds.

–

The red LED turns on for 2 seconds.

When a transmitter, that is matched on a even position (2, 4,

6, etc.), is activated:

–

Relay 2 switches on for 2 seconds.

–

The red LED blinks 1 second on, 1 second off, 1 second on.

Battery low indication (until the battery is exchanged)

–

The red LED flashes during 2 seconds, then flashes 1

second every 10 seconds.

NOTICE!

A MIYN46 transmitter in repeated alarm mode extends the

behavior of the LE10 by approximately 26 minutes. If several

MIYN46 transmitters are programmed, each activated

transmitter stops the sequence and starts its own sequence.