Bosch Appliances Food Processor MUM 7000 UC User Manual

8

no flour or oil on the surface. A clean
smooth surface will provide the best
footing for the suction cup feet on
the power unit and will limit slipping
and/or “walking.”

Plug power unit into power supply.
Unwind the power unit’s cord to
appropriate length and plug it into
a convenient nearby receptacle.

Remove motor drive cover.
Remove motor drive cover from mono-
drive, see figure 2c.

Select attachment to be used.
Select attachment you wish to use
and place on power unit. See specific
instructions for attachment selected.
Specific instructions are located on
pages listed below:

Mixing bowl w/dough hook ........  9-11
Mixing bowl w/twin whisks ....... 11-14
Blender ..................................... 15-17
Slicer/shredder ......................... 17-20
Food processor ........................ 20-24

Operate unit with rotary switch.
Once the attachment is in place, the
speed of its moving components can
be controlled through the use of the
rotary switch at the front of the power
unit. See figure 2a. The rotary switch
has six positions:

a. “M,” a momentary “pulse” position

that provides full speed and power
for the time it is held in position.

b. “O/Off,” the off position.
and
c. Four speeds labeled 1, 2, 3 and 4.

Speed 1 is the lowest speed. The
speed increases with each
succeeding step up to the highest
speed, speed 4.

All models of the Bosch Concept
Series Kitchen Machines incorporate
an electronic safety control to protect
the motor. If the safety becomes
activated, the indicator will flash. See
TROUBLESHOOTING at the back of
this manual if status indicator is
flashing.

Turn power unit off.
When your work with the attachment
is completed or the capacity of the
batch feed attachment has been
reached, turn the power unit to off
position, “O/Off” and unplug.

Remove the attachment.
Remove the attachment from the
power unit, per instructions for the
specific attachment being used.

Continue use.
If the attachment was of the batch feed
type and you wish to continue using
the attachment, empty the bowl or jar
of the attachment per its specific
instructions and reinstall the
attachment as before. Repeat the
steps 5 through 7 as often as
necessary to complete necessary
work.

Work completed,
remove attachment.
If the attachment is of the continuous
feed type or is the batch type and you
have completed the work you wished