Barco Automobile Accessories not available User Manual
2.2 Installation Guidlines
Rigging & Mounting Guidelines
●
C11 and C8v C-series tiles have an IP66 rating and are suitable for use in most indoor and outdoor installations except where water immersion
could occur. This conforms to the International Electrotechnical Commission (IEC) standard 60529.
could occur. This conforms to the International Electrotechnical Commission (IEC) standard 60529.
●
The C7 tiles have an IP50 rating and are suitable for indoor use only.
●
Use caution when installing the display. C-series tiles weigh 6.4 kg (14.1 lbs)/tile.
●
Ensure rigging hardware is able to handle the weight of the entire C-series system with appropriate safety factors.
●
External rigging hardware must be properly installed prior to hanging C-series tiles.
●
Do not hang more than 25 C-series tiles (10 m) tall with the integral rigging hardware.
●
When rigging observe the maximum number of panels that can be hung or floor supported.
●
Displays >10 m tall require an auxiliary frame system not supplied by Barco.
●
Handle is intended for carrying a single tile only. Do not use for safety, tie-off, climbing, or lifting.
Power
Observe the following power guidelines when setting up your C-series display.
The table below indicates min/max power consumption.
The table below indicates min/max power consumption.
When running typical video content, the duty cycle (average power consumption) is about 30% of
maximum. See
for more details on maximum daisy chain power consumption limits for PDB-5 and break-in cables.
NOTE
For installations where a residual current device (RCD) or similar device will be used on the mains power to the display, please take into account that C-
series tiles have an earth leakage of 85 micro-amps per tile.
series tiles have an earth leakage of 85 micro-amps per tile.
Data
Observe the following data limits when setting up your C-series display.
Temperature
C-series installations must take into account the operating temperature of the tiles. The ambient operating temperature for a C-series tile is -20°C to 45°C.
NOTE
C-series tiles have an internal temperature sensor that shuts down the tile’s output (brightness is set to 0) when internal temperature is too high. The
brightness will return to normal when the internal temperature has cooled sufficiently.
brightness will return to normal when the internal temperature has cooled sufficiently.
Fixture
Max power
consumed @
full white
Minimum
power
consumed in
black
Maxiumum
Brightness
C7
100 watts
12 watts
2000 nits
C11
85 watts
12 watts
5000 nits
C8v
55 watts
12 watts
8000 nits
Fixture
Max panels per
PDB-5 or switch
output
Max Panels
per Vizomo
per Vizomo
output
Max Panels
per Vizomo
C7
8
80
320
C11
16
180
720
C8v
25
300
1200
2. C-series Tile . 7
PXL System