Baratza Forte-AP User Manual
17
Forte
TM
Manual
CARE and CLEANING
TM
Forte
If the grinder is used daily, the burrs (steel or ceramic) should be cleaned at least
every few months using tablets (see below for Automatic Cleaning) or with a
stiff brush. Proper cleaning enables the burrs to achieve the most consistent
grind possible. Cleaning also removes some coffee oils, which will stale and
degrade the flavor of the ground coffee.
every few months using tablets (see below for Automatic Cleaning) or with a
stiff brush. Proper cleaning enables the burrs to achieve the most consistent
grind possible. Cleaning also removes some coffee oils, which will stale and
degrade the flavor of the ground coffee.
Caution
Do not put the bean hopper, hopper lid, ground coffee bin, or PortaHolder in the
dishwasher. Hand wash only. Do not immerse the grinder housing in water. Do
NOT wash the burrs with water.
dishwasher. Hand wash only. Do not immerse the grinder housing in water. Do
NOT wash the burrs with water.
Replacing the Burr
Make sure ALL coffee grounds and powder is removed from the mating surfaces
of the grind chamber and the upper burr carrier before reinstalling. Even a very
small speck of coffee powder will throw off your calibration. With your hand,
gently thread the upper burr carrier, turning counter-clockwise until finger-
tight (almost 1 full turn). Using the Baratza Burr Tool, rotate the burr carrier
counter-clockwise an additional 1/8 inch or 2mm (do not over tighten).
of the grind chamber and the upper burr carrier before reinstalling. Even a very
small speck of coffee powder will throw off your calibration. With your hand,
gently thread the upper burr carrier, turning counter-clockwise until finger-
tight (almost 1 full turn). Using the Baratza Burr Tool, rotate the burr carrier
counter-clockwise an additional 1/8 inch or 2mm (do not over tighten).
Replacing the Bean Hopper
To replace the bean hopper, line up the two small tabs on the base of the hopper
with their respective slots in the top of the grinder housing and insert the
hopper into the grinder. Once the hopper is in place, rotate it clockwise until it
with their respective slots in the top of the grinder housing and insert the
hopper into the grinder. Once the hopper is in place, rotate it clockwise until it