Woodstock SHOPFOX W1813 User Manual
-38-
N(/(*(/Fg\e<e[N`[\9\ckJXe[\i
J<I
M
@:<
-% Remove the three cap screws securing the left rear
conveyor roller bracket to the conveyor support, but
leave the roller assembly and the bracket in place,
as shown in
leave the roller assembly and the bracket in place,
as shown in
=`^li\*/.
.% Loosen, but do not remove, the upper cap screws on
the left side of the conveyor assembly that secure
the sander assembly to the mounting brackets (see
=`^li\*- on GX^\*.).
the sander assembly to the mounting brackets (see
=`^li\*- on GX^\*.).
Efk\1Cffj\e`e^k_\j\ZXgjZi\njn`cci\c`\m\k_\
jkiX`efek_\YiXZb\kj]fik_\e\okjk\g%
jkiX`efek_\YiXZb\kj]fik_\e\okjk\g%
/% Remove the two hex bolts and flat washers on the
left side of the conveyor that secure the sander
assembly mounting brackets to the cabinet stand
(see
assembly mounting brackets to the cabinet stand
(see
=`^li\*/).
0% With assistance, lift the left side of the conveyor
assembly up approximately 1", then remove the con-
veyor belt, as shown in
veyor belt, as shown in
=`^li\*0.
('% Slide the new conveyor belt onto the conveyor
assembly, then re-install the parts removed or loos-
ened in reverse order.
ened in reverse order.
((% Re-tension the conveyor belt, and adjust the track-
ing (refer to
GX^\j)0 *').
()% Re-adjust the sanding drum and conveyor parallelism
(refer to
GX^\*)).
=`^li\*0% Removing the conveyor belt
from the machine.
NOTICE
8]k\i cffj\e`e^ k_\ c\]k Zfem\pfi ifcc\i YiXZb\k#
k_\ i\Xi Zfem\pfi ifcc\i Xjj\dYcp `j jlggfik\[ Yp
`kj XkkXZ_d\ek kf k_\ Zfem\pfi dfkfi Xjj\dYcp%
?fn\m\i#kfXmf`[[XdX^`e^k_\ifcc\iXjj\dYcp#;F
EFKglklee\Z\jjXipjkiX`efek_`jXjj\dYcp%
k_\ i\Xi Zfem\pfi ifcc\i Xjj\dYcp `j jlggfik\[ Yp
`kj XkkXZ_d\ek kf k_\ Zfem\pfi dfkfi Xjj\dYcp%
?fn\m\i#kfXmf`[[XdX^`e^k_\ifcc\iXjj\dYcp#;F
EFKglklee\Z\jjXipjkiX`efek_`jXjj\dYcp%
=`^li\*/% Rear conveyor roller bracket
unattached from the conveyor support.
Rear Conveyor
Roller Bracket
Hex Bolt
(1 of 2)