Woodstock SHOP FOX W1668 User Manual
-
14
-
Speed Change
ADJUSTMENTS
Unplug the drill press before changing speeds.
The Oscillating Drill Press has 12 speeds ranging
from 250 to 3050 RPM. There is a speed chart
located under the belt guard and one on the fol-
lowing page. Refer to the speed chart while
reading these instructions.
The Oscillating Drill Press has 12 speeds ranging
from 250 to 3050 RPM. There is a speed chart
located under the belt guard and one on the fol-
lowing page. Refer to the speed chart while
reading these instructions.
1. Loosen the belt tension lock knob.
Figure 21.
2.
The motor is now free to move and can be
pulled toward the front of the drill press.
This will take tension off the V-belts.
pulled toward the front of the drill press.
This will take tension off the V-belts.
3.
Locate the desired speed on the chart and
move the V-belts to the desired V-grooves
on the motor, idler and spindle pulleys.
Figure 22.
move the V-belts to the desired V-grooves
on the motor, idler and spindle pulleys.
Figure 22.
4.
Push the motor toward the back of the
headstock, the motor support rod is spring
loaded and will follow the motor. Figure
23. Tighten the lock knob.
headstock, the motor support rod is spring
loaded and will follow the motor. Figure
23. Tighten the lock knob.
5.
Close the cover. The motor will not start
until the cover is closed.
until the cover is closed.
Figure 21. Loosening lock knob
Figure 22. Adjusting belt to desired speed.
Figure 23. Push motor toward back of machine.
Unplug the drill press
before changing speeds
to avoid accidental start
up. Failure to do this may
result in serious personal
injury.
before changing speeds
to avoid accidental start
up. Failure to do this may
result in serious personal
injury.