Weber 1100 Owner's Manual

Complete accessory installation

You will need: Warm-Up Basket, warming rack, work table,
accessory trays, three tubing plugs, thermometer and a
hammer.

Insert one end of the Weber Warm-Up Basket into the hole
in the right end of the lid and the other end into the slot in
the left end of the lid. Figure 28 (a).

Set the warming rack into the slots at the rear of the
cooking box. Figure 28 (b).

Set the work table onto the left side rails. Figure 28 (c).

Set the accessory trays in place between the two frame
connectors. Figure 28 (d).

Insert the thermometer into its holder. Figure 28 (e).

Insert the tubing plugs into the ends of the frame. To fully
seat the plugs, you may have to tap them lightly with a
hammer. Figure 28 (f).



Position slide bar assembly on the outside of the caster
frame. Put a nylon washer on each 1 3/4 inch screw, insert
screws through frame and slide bar assembly and add
nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 26.

View from front
of barbecue

Notch to the front

Slide bar

To lower table: Pull support rod up to disengage slide lock,
and lower table. To raise table, lift table up and engage slide
in locked position. Figure 27.

View from rear
of barbecue

Support rod

Locked position

Unlocked position

Slide