Woodstock Shop Fox Fence W1410 User Manual

Shop Fox

Fence

-7-

Figure 4. Mounting the rear rail.

Step 8.

The distance between the front and back rail

should be 27'' ±

⁄

''. Add or remove washers to

achieve this measurement. If your measurement

does not fall within this range, refer to Section V

on page 20 for further instruction.

Step 9.

Measure the distance between both ends of the

rails to determine if they are parallel. The differ-

ence between the two ends of the rails should be

no more than ±

⁄

Note: relative parallelism between the ends of the

rails is not critical to the accuracy of the fence, but

will prevent the unlocked fence from moving by

itself in the direction of the taper. Extra washers

may be added or removed from between the table

and back rail to achieve parallelism.

Step 10.

Mount the cross brace to the end of the rails using

the

⁄

-16 x 1'' Hex Bolts and Flat Washers provid-

ed. Leave the bolt in the middle of the brace loose

until the bolts at the ends of the brace are tight.