Woodstock M1049 User Manual
-26-
D('+09\eZ_kfgCXk_\ D]^%J`eZ\/&'0
FG
<
I
8
K@FEJ
Using Centers
The MT#2 dead center is used in the tailstock, and the
MT#3 in the lathe spindle. When used in the tailstock,
make sure to keep the dead center tip and workpiece
lubricated to prevent tip galling.
MT#3 in the lathe spindle. When used in the tailstock,
make sure to keep the dead center tip and workpiece
lubricated to prevent tip galling.
To install a dead or live center into the tailstock, do
these steps:
these steps:
1. Feed the quill out about 1" and insert the dead
center (Figure 23). The mating tapers provide the
locking action.
locking action.
2. Move the tailstock into position and lock the
tailstock in place.
3. Feed the quill into the workpiece.
Note:
DXb\jli\k_\i\`jXZ\ek\i[i`cc\[_fc\`ek_\
\e[f]k_\nfibg`\Z\]fik_\[\X[Z\ek\i%
4. Lock the quill into place once the live center and
the part rotate together.
Note:
K_\hl`ccdXpe\\[kfY\X[aljk\[[li`e^
fg\iXk`fe%
5. To remove the dead center, retract the quill until
the dead center pops free.
To install a MT#5 dead center into the spindle, do these
steps:
steps:
1. Remove the chuck from the spindle.
2. Make sure all mating surfaces are clean and are wiped
with a thin coat of oil.
3. Install the dead center in the spindle.
4. Attach the faceplate to the spindle.
Note:
N_\elj`e^k_\[\X[Z\ek\i`ek_\jg`e[c\#
lj\XcXk_\[f^jfk_XkpfligXikn`ccifkXk\n`k_
k_\jg`e[c\Xe[efkjg`efek_\[\X[Z\ek\ik`g%
k_\jg`e[c\Xe[efkjg`efek_\[\X[Z\ek\ik`g%
=`^li\24% Faceplate and dead center
installed.
=`^li\23% Live center installed.
=X`cli\kfb\\g[\X[Z\ek\igf`ekn\cc
clYi`ZXk\[n`cc^Xcck_\[\X[Z\ek\iXe[
nfibg`\Z\%
clYi`ZXk\[n`cc^Xcck_\[\X[Z\ek\iXe[
nfibg`\Z\%