Woodstock SHOP FOX W1677 User Manual

-44-

W1677/W1711 10" Table Saw

The angle pointer allows you to set the angle to the cor-

rect position on the angle gauge after setting the 90˚ and

45˚ angles.

To set the angle pointer, do these steps:

1. Make sure that you have performed the 90˚ and 45˚

instructions in the

Blade Tilt Stop Bolts section on

Page 39 before beginning.

2. Turn the blade to 90˚.

3. Check the angle pointer. If it reads “0”, then it is

already adjusted correctly.

4. If it is not pointing to “0”, then loosen the adjust-

ment screw shown in

Figure 74. Set the pointer to

the “0” then tighten the adjustment screw.

Angle Pointer

Figure 74. Blade tilt pointer.

The miter gauge (shown in

Figure 75) allows you to sup-

port the workpiece while crosscutting. In order to be

accurate, the miter gauge pointer needs to be adjusted

before use.

To set the miter gauge pointer, do these steps:

1. Loosen the adjustment knob shown in Figure 75, so

the miter gauge rotates back and forth.

2. Using a square, adjust the miter body so it is square

to the miter bar.

3. Tighten the knob so the miter body is secure.

4. Loosen the setscrew on the miter slide next to the

angle pointer, and adjust the angle pointer so it

reads “0”. Tighten the nut so the angle pointer is

secure.

5. Check and adjust if necessary.

Miter Gauge

NOTICE

If the miter bar fits too loose in the

miter slot, it can be adjusted by tight-

ening the set screws on the side of the

miter slide. These set screws push the

thin walls of the slide out slightly to

create resistance while in the miter

slot. Do not overtighten.

Figure 75. Miter gauge.

Adjustment Knob