Alpine CDA-105RI User Manual
36
-EN
• Communication error.
- Turn the ignition key OFF, and then set to ON again.
• Abnormal current is run to the USB connector device.
- You can solve the problem by switching the source, turning the
unit power off, or ACC to the OFF position.
• A USB device that is not supported by the unit is connected.
- Connect a USB device that is supported by the unit.
• A USB memory is not connected.
- Make sure the USB memory device is correctly connected and
the cable is not excessively bent.
• No song (file) is stored in the USB memory.
- Connect the USB memory device after storing songs (files).
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
• Text information that is not recognizable by the unit has been
input.
- Use a USB memory device with input text information that is
- Use a USB memory device with input text information that is
supported by the unit.
• The iPhone/iPod is not connected.
- Make sure the iPhone/iPod is correctly connected (refer to
Make sure the cable is not bent excessively.
• There are no songs in the iPhone/iPod.
- Download songs to the iPhone/iPod and connect to this unit.
• Communication error.
- Turn the ignition key off, and then set to ON again.
- Reset the iPod.
- Check the display by reconnecting between the iPhone/iPod
- Reset the iPod.
- Check the display by reconnecting between the iPhone/iPod
and this unit, using the iPod cable.
• Caused by the iPhone/iPod Software Version not being
compatible with this unit.
- Update the iPhone/iPod Software Version to be compatible
- Update the iPhone/iPod Software Version to be compatible
with this unit.
• The iPhone/iPod is not verified.
- Change another iPhone/iPod.
• Abnormal current is run to the USB connector device.
- You can solve the problem by switching the source, turning the
unit power off, or ACC to the OFF position.
• A USB device that is not supported by the unit is connected.
- Connect a USB device that is supported by the unit.
• Malfunction occurred as a result of the speaker cable shorting on
the car chassis.
- Route the cable correctly, and set POWER IC to ON (page 20).
- Route the cable correctly, and set POWER IC to ON (page 20).
If the above solution does not work, consult your nearest
dealer.
dealer.
Indication for USB memory
DEVICE ERROR
NO USB UNIT
NO SUPPORT
Indication for iPhone/iPod Mode
Indication for all Modes
DEVICE ERROR