Whirlpool W10018010 User Manual

IMPORTANT: Clean the hood and grease filters frequently 
according to the following instructions. Replace grease filters 
before operating hood.

Check that lights are cool before cleaning the hood.

Clean the range hood with a mild detergent and soft cloth. Do not 
use abrasive cleanser or steel-wool pads.

The filters should be washed frequently. Place metal filters in 
dishwasher or hot detergent solution to clean. Drain water 
through edge holes and let each filter dry thoroughly before 
replacing it.

1. Turn off blower and lights. Check that the halogen lamp is 

cool.

2. Push handle toward the rear and pull downward.

3. Pull filter toward the front.

1. Insert back edge of filter into rear channel of the filter 

opening.

2. Push handle toward the rear and push filter up.

3. Pull filter toward the front and insert into front channel.

The charcoal filters capture unpleasant cooking odors. They can 
be cleaned and reactivated. With normal use the filter should be 
cleaned every second month (when using the hood 2.5 hours per 
day, on average).

Clean the filter in the dishwasher using normal detergent and 
choosing the highest temperature setting. Wash the filter 
separately. To reactivate the filter, the filter should be dried in 
an oven for 10 minutes with a maximum temperature of 
210°F (100°C).

After approximately 3 years of use, the charcoal filter should be 
replaced. See “Assistance or Service” section to order 
replacement charcoal filters.

1. Turn off blower and lights. Check that range hood is off and 

halogen lamp is cool.

2. Remove the metal grease filters by pushing handle toward 

the rear and pull downward.

3. Pull filter toward front.

4. Set the filter face down on a protective cover such as a towel.

5. Remove metal wires and clean or discard charcoal filter.

6. Install cleaned or replacement charcoal filter on rear of metal 

filter with metal wires provided in filter packaging.

1. Insert back edge of filter into rear track of the filter opening.

2. Push handle toward the rear and push filter up.

3. Pull filter toward the front and insert into front track.

Turn off the range hood and allow the halogen lamps to cool. 
Replace bulb by using a tissue to handle bulb or while wearing 
cotton gloves. Do not touch bulb with bare fingers.

If new lights do not operate, make sure the lamps are inserted 
correctly before calling service.

1. Disconnect power.

2. Use a flat-blade screwdriver and gently pry the light cover 

loose.

3. Remove the lamp and replace with a 12-volt, 20-watt 

maximum, halogen lamp made for a G-4 base.

4. Replace the light cover.

5. Reconnect power.