Whirlpool WFW9550WL User Manual

Page of 52
23
Did you use enough HE detergent? 
 
Use enough detergent to remove soil and hold it in suspension. 
Use only HE detergent. Follow the manufacturer’s instructions 
 
to determine the amount of detergent to use.
Is there above average iron (rust) in water?
 
You may need to install an iron filter.
Did you properly sort the load?
 
Sort dark clothes from whites and lights.
Did you unload the washer promptly?
 
To avoid the transfer of dye, unload the washer as soon 
 
as it stops.
Did you use a fabric softener dispensing ball?
 
Dispensing balls will not operate correctly with this washer. 
 
Add liquid fabric softener to the fabric softener compartment.
Did you use powdered detergent in a low-speed cycle? 
 
Consider using liquid detergent.
Did you use Quick Wash on a large load?
 
For best results, use Quick Wash for small, lightly soiled loads.
Load is wrinkled
Did you unload the washer promptly?
 
Unload the washer as soon as it stops.
Did you use the right cycle for the load being washed?
 
Use the Delicate, Hand Washables, or another cycle with a 
 
low-spin speed to reduce wrinkling.
Did you overload the washer?
 
The wash load must be balanced and not overloaded. 
 
Loads should tumble freely during washing.
Gray whites, dingy colors
Did you properly sort the load?
 
The transfer of dye can occur when mixing whites and colors in 
a load. Sort dark clothes from whites and lights.
Was the wash temperature too low?
 
Use hot or warm washes if safe for the load. Make sure your hot 
water system is adequate to provide a hot water wash.
Did you use enough detergent, or do you have hard water?
 
Use more detergent for washing heavy soils in cold or hard 
water.
Cycle too long
Did you choose the Deep Clean with Steam option?
 
In this case, the heater and steamer will be activated to provide 
maximum cleaning performance. Additional time will be added 
to the regular cycle to heat the water. This additional time will 
depend on the load size and the hot water inlet temperature.
Is the hot water inlet set to the recommended temperature 
of 120°F (49°C)?
 
 
A hot water temperature below the recommended setting will 
increase heating time.
Is “SUD” shown in the display? 
 
Excessive sudsing has been detected and a suds routine has 
been started to reduce excessive suds. This routine will add 
 
time to the original cycle.
Did you wash a large load using the Quick Wash cycle? 
 
The Quick Wash Cycle is designed for smaller load sizes 
 
(2-3 items of lightly soiled garments). If larger loads are washed 
using this cycle, wash time will be increased. 
Did you wash a large load using a gentle cycle? 
 
When using the Delicate and Hand Washables cycles you 
should use small loads. This ensures a gentle 
 
wash for your garments without increasing cycle times.
Did the load cause imbalance?
 
When too much imbalance occurs, an imbalance routine will 
start to redistribute the load. During the imbalance routine, 
 
the time displayed may pause until this activity is complete, 
 
then resume with the remainder of the cycle.
Door locked at end of wash cycle
Did all of the water drain out of the washer during the spin?
 
Select DRAIN/SPIN to remove any water remaining in the 
washer. The washer door will unlock at the end of the drain.